Desks that Convert to Table for our Tiny House on Wheels

Step 1

Build two of the leg sets, using 3/4" pocket holes and 1-1/4" pocket hole screws whenever 3/4" thick material is involved, and 1-1/2" pocket holes and 2-1/2" pocket hole screws whenever 1-1/2" material is exclusively used.

Step 2

Attach the two leg sets together with the 1x2s and top and 2x2s on bottom.

Step 3

Drill 3/4" pocket holes on all sides of the 1x4 aprons boards, including the top for attaching the tabletop in later steps. Attach to legs, 1x2s with 3/4" pocket hole screws and glue. All aprons are inset 1/4" from outside.

Step 4

Drill 3/4" pocket holes on ends and top edge of drawer supports. Attach drawer supports inside aprons with 1-1/4" pocket hole screws and glue.

Step 5

Step 6

Attach drawer face to drawer with 1/8" gap along bottom and side edges. A larger gap on top will help the drawer open and close easier, but will be hidden under tabletop front edge. Attach with 1-1/4" screws from inside with glue (can use pocket hole screws).

Step 7

Remove drawer. Place desk inverted on underside of tabletop. Attach through predrilled pocket holes to tabletop, making sure project is square, using 1-1/4" pocket hole screws and glue. If creating the hinged desk to table option, make sure the tabletop does not overhang on the back edge and side edge that will be hinged to the second desk.

Step 8

To create the converting desks, add hinges along the back legs.

Finishing

Sand all surfaces, starting with a medium grit and finishing with fine. Wipe off the dust, fill any holes or gaps with wood filler, and sand smooth once dry. Apply primer if you're painting, then finish with your choice of paint or stain and seal with a durable clear topcoat. For outdoor projects, use exterior-rated primer, paint or stain, and sealer so the piece stands up to the weather.