Easiest Corn Hole Board Plans with Free Printable PDF
Build a regulation-size pair of folding cornhole boards with just a drill and jigsaw. This beginner-friendly plan includes clear diagrams, a full-size hole pattern, and a free printable PDF.
Specifications
| Project type | Outdoor Projects |
|---|---|
| Room | Outdoor |
| Difficulty | Starter Projects |
Shopping List
4 - 2x4 boards, 8 feet long
2 - 1/2-inch plywood panels, 23-3/4 inches x 47-3/4 inches (or two 2-foot x 4-foot panels)
4 - 3/8-inch bolts, 4 inches long
4 - 3/8-inch nuts
8 - flat washers sized for the bolts
16 - 2-1/2-inch exterior screws
32 - 1-5/8-inch exterior screws
120-grit sandpaper
Cut List
4 - 2x4 @ 47-3/4 inches (frame sides)
4 - 2x4 @ 20-3/4 inches (frame ends)
4 - 2x4 @ 11-3/4 inches (folding legs)
2 - 1/2-inch plywood @ 23-3/4 inches x 47-3/4 inches (tops)
Cut one 6-inch-diameter scoring hole in each plywood top, centered side-to-side and 9 inches down from the top edge.
Tools
- measuring tape
- speed square
- drill
- 3/8-inch drill bit
- jigsaw with wood blade
- wrench
- sander
Step-by-step Instructions
Prepare the frame boards and legs
Cut the 2x4 frame pieces as shown, measuring and cutting as you go. Drill the 3/8-inch pivot holes in the side boards. Mark, drill, and trim all four folding legs using the diagram.
Assemble the boards
Assemble both frames with the bolt holes on the same side. Install the folding legs with bolts, washers, and nuts. Square each frame as you fasten the plywood top, then cut and sand the 6-inch scoring hole.
Mark the scoring holes
Use this full-size hole pattern only from the downloaded PDF printed at 100% scale. Confirm that the printed circle measures exactly 6 inches before tracing it onto the plywood.
Finishing
Sand all surfaces, starting with a medium grit and finishing with fine. Wipe off the dust, fill any holes or gaps with wood filler, and sand smooth once dry. Apply primer if you're painting, then finish with your choice of paint or stain and seal with a durable clear topcoat. For outdoor projects, use exterior-rated primer, paint or stain, and sealer so the piece stands up to the weather.
Source (temporary): https://www.ana-white.com/woodworking-projects/easiest-corn-hole-board-plans-free-printable-pdf