K Cup Holder Ladder
Keep K cups on display and ready to serve with this handy little k cup ladder organizer. Super easy to build and uses just one 1x2! from
Specifications
| Project type | Kitchen Cabinet Plan, Accessories and Serving |
|---|---|
| Room | kitchen |
| Difficulty | Starter Projects |
| Estimated cost | Under $20 |
Dimensions
Use the size-specific shopping and cut lists below.
Shopping List
1 - 1x2 @ 6 feet long
1-1/4" brad nails
wood glue
Cut List
2 - 1x2 @ 15" - both ends cut at 10 degrees off square, long point to short point measurement, ends ARE parallel
5 - 1x2 @ 8"
Tools
- measuring tape
- square
- pencil
- safety glasses
- jigsaw
- compound miter saw
- nailer
Step-by-step Instructions
OPTIONAL: Cut the back top corner off square, so it rests flat to the back wall.
NOTE: The top and bottom angles are 10 degrees, not 15 degrees
Measure and mark out the placement of the horizontal boards.
I liked a 1-5/8" spacing for the K Cups, but 1-3/4" could have worked too.
Finishing
Sand all surfaces, starting with a medium grit and finishing with fine. Wipe off the dust, fill any holes or gaps with wood filler, and sand smooth once dry. Apply primer if you're painting, then finish with your choice of paint or stain and seal with a durable clear topcoat. For outdoor projects, use exterior-rated primer, paint or stain, and sealer so the piece stands up to the weather.
Source (temporary): https://www.ana-white.com/woodworking-projects/k-cup-holder-ladder