Large Firewood Box
Build a firewood box from one sheet of 3/4" plywood and some common boards. Holds about 1/4 of a cord of wood. Very sturdy. Put together with construction screws (no pocket holes). from Update After Years of Use We've been using this firewood box to store wood near our wood stove in Alaska for several years. It has held up (not wobbly) and is very user friendly. We especially appreciate that it keeps the bark and dirt contained. I would recommend this firewood box to anyone that has the space and goes through a lot of firewood.
Specifications
| Project type | Other Projects |
|---|---|
| Room | Entryway and Mudroom |
| Difficulty | Intermediate |
Dimensions
Use the size-specific shopping and cut lists below.
Shopping List
- 1 - sheet of 3/4" thick plywood, cut into four pieces, each 48" x 24" or purchase precut panels 48" x 24" - AC or Hardwood Plywood recommended
- 3 - 2x2 @ 8 feet long
- 3 - 1x12 @ 4 feet long
- 2" self tapping wood screws and wood glue
Cut List
- 4 - 3/4" plywood pieces 24" x 48"
- 2 - 2x2 @ 48"
- 2 - 2x2 @ 35" - ONE end cut at 30 degrees off square, short point measurement
- 2 - 2x2 @ 24-1/4" - BOTH ends cut at 30 degrees off square, long point to short point measurement, ends are parallel
- 3 - 1x12 @ 48"
Tools
- measuring tape
- pencil
- safety glasses
- drill
- circular saw
- sander
Step-by-step Instructions
Step 1
If you are using a full 3/4" plywood panel (instead of buying the four precut pieces), mark the centers as shown below and cut on the line to create four equal sized pieces.
Step 2
On two of the panels, mark the top corners and cut off with a circular saw.
Step 3
Place the 2x2 supports on the side panel, edges flush to top and front and attach with screws and glue. Build the second panel in mirror.
Step 4
Attach bottom to the two side panels with glue and the screws.
Step 5
Apply glue to the back edges and attach fourth panel to the back with the screws.
Step 6
Add the 1x12 pieces to thefront and back to complete the firewood box.
Finishing
Sand all surfaces, starting with a medium grit and finishing with fine. Wipe off the dust, fill any holes or gaps with wood filler, and sand smooth once dry. Apply primer if you're painting, then finish with your choice of paint or stain and seal with a durable clear topcoat. For outdoor projects, use exterior-rated primer, paint or stain, and sealer so the piece stands up to the weather.
Source (temporary): https://www.ana-white.com/woodworking-projects/large-firewood-box-free-plans