Simple Kids Play Table with Paper Roll Holder and Shelf

Step 1

Build the two leg end sets with your Kreg Jig. Also, drill 3/4" pocket holes facing upward for attaching the tabletop in later steps.

Step 2

Also drill 3/4" pocket holes facing upward on the 1x4s side aprons for attaching the tabletop in later steps. Then add the side aprons and shelf trim to create the table frame.

Step 3

NOTE: You may wish to attach the tabletop (step 4) before adding the bottom shelf so you don't need a right angle drill to attach the tabletop. Drill 3/4" pocket holes around all the edges of the bottom shelf. Attach with 1-1/4" pocket hole screws and wood glue. ALTERNATIVE METHOD: You can subsitute the plywood for 1x3 slats to save money and not need a table saw to cut the bottom shelf. Just attach with pocket holes on the underside. [[{"type":"media","view_mode":"media_original","fid":"3154909704","attributes":{"alt":"","class":"media-image","style":"width: 650px; height: 487px;"}}]]

Step 4

Drill 3/4" pocket holes along 1 edge of 1 of your 1x12 boards. Attach with glue to the second 1x12 board with 1-1/4" pocket hole screws. Place upside down on work surface (pocket holes facing upward) and position base on tabletop, also upside down. Attach through predrilled pocket holes with glue and 1-1/4" pocket hole screws.

Step 5

Finishing

Sand all surfaces, starting with a medium grit and finishing with fine. Wipe off the dust, fill any holes or gaps with wood filler, and sand smooth once dry. Apply primer if you're painting, then finish with your choice of paint or stain and seal with a durable clear topcoat. For outdoor projects, use exterior-rated primer, paint or stain, and sealer so the piece stands up to the weather.